Reason #9 – Interface Changes (or Lack There Of)

When compared to SprutCAM 9, the interface for SprutCAM 10 remains mostly unchanged. This is fantastic, because it means the learning curve for SprutCAM 9 users is as easy as it gets.

The real only difference is that lathe properties are now on the task bar where job assignment resides as opposed to being in the operation parameter page.

Essentially, it went from here:

91

To here:

92

Reason 10/10 Coming Tomorrow!

Interface Changes (Or Lack There Of) – Reason 9/10 to Get SprutCAM 10
Facebooktwittermail
Tagged on:

Leave a Reply

Skip to toolbar