SprutCAM has the capability of programming multitask turning machines with sub spindle (MTM). It enables the creation of NC programs for simultaneous machining of several parts by multiple tools.
In the modern batch production environment batch production, multi-task machines (MTM) are becoming much more popular. Their key benefit is the high performance combined with a relatively small footprint. Extra capacity is achieved due to their multi function abilities. In fact, a multi-task machine can combine two, three or even four machines in one.
The image above shows a typical type of multi-task machine. It comprises a turning center with a turret and a 6-axis milling machine. In addition, there is a programmable sub-spindle, providing second op. machining of the part. The standard technological process of machining on such a machine assumes:
- The work piece is retained in one of the spindles.
- Turning is performed using the lower turret.
- Milling is undertaken by the upper rotating turret.
- The work piece can be transferred to the other spindle.
- A new workpiece can be loaded into the free chuck.
- The simultaneous working of both parts is possible. In this case, turning is performed using one of the spindles, at the same time milling is performed using the other spindle. If required, the turning and milling turrets can machine using either spindle.
- Unloading of the finished part from the second spindle.
- Loading of the next workpiece.
Control of each section of the multi-task machine is usually maintained by a separate (channel) controller, each channel runs its own program. Consequently, the programming of such a machine involves the task of creating two or more programs; one for each control channel, consequently, the task of synchronization of these channels / programs will arise. To ensure correct coordination for the machining of multiple channels, it is necessary to use the controls “waiting” capability. In our example the milling turret will be unable to start machining the work piece in the left chuck whilst this work piece is being turned using the lower turret.
To ensure a really efficient use of a multi-task machine, it is necessary to minimize the waiting time. This task ideally requires the equal distribution of the load among executive devices. In our example, this means that the amount of machining performed by the turret and the spindle should be approximately equal. Moreover, processing time on the left and the right chucks should also be balanced.
At a time when there are several work pieces and several executive devices simultaneously working in one area, realistic simulation of the whole process including collision checking of all the objects in the area becomes really important. Only by having such simulation capabilities, can you be really confident of the accuracy of the developed machining process which will essentially cut the likelihood of any possible collisions resulting from programming errors.
So, the SprutCAM system possesses all of the abilities that are required for the programming of multitask machines. Among these are:
- Full kinematic schemes of the machines including several executive devices (spindles / turrets etc.), several places for workpiece positioning and the capability of sharing axes between control channels.
- Capability of programming the workpiece loading, unloading and interception.
- Means for load evaluation and balancing on each of the control channels. Accessible channel-to-channel work transfer mechanism.
- Interactive ‘waiting’ points setting ability (timing points).
- Real-time realistic simulation of simultaneous working process by all of the channels.
- Collision checking of all the objects in the working area.